DIY Foam Crown Molding – 4 in. Wide 8 ft. Long – #CC 453

"Foam Molding was installed using Instant Grab water-based adhesive a few inches below the ceiling line. Painted the molding semi-gloss white. The reflective tape was then placed on the back of the molding. The strip lights were installed after the molding."
Tips: Measured around the room, pencil marks on the wall, to make it even. Needed 2 people to get it straight and hold it in place for a minute. Before installing, paint and stick reflective tape on styrofoam. After installation dries, stick-on strip lights. Hid the hole behind the styrofoam to finish wiring for lights. Work on the molding in the room you are going to install it in because it is fragile to be moving around.
- Patricia Boegelein